KEYES ARDUINO flame module
Flame module Interface module and number 13 comes with LED build a simple circuit to produce flame warning lamp 13 comes with digital interfaces of the LED, the flame sensor connected digital three interfaces, when the flame sensor senses There are key signal detected, LED lights, otherwise off.
Sensor for flame wavelengths between 760 nm to 1100 nm infrared is most sensitive 60 degree detection sensor Two outputs mode: AO: analog output- real-time output voltage signal on the thermal resistance DO: when the temperature reaches a certain threshold- the output high and low signal threshold adjustable via potentiometer
Schematic
- Arduino GND --> Module G
- Arduino +5V --> Module +
- Arduino digital 4 --> Module D0
- Arduino A3 --> Module A0
Example Code
//Example for KY-026 //TkkrLab int Led = 13 ;// define LED Interface int buttonpin = 3; // define the flame sensor interface int analoog = A3; // define the flame sensor interface int val ;// define numeric variables val float sensor; //read analoog value void setup () { pinMode (Led, OUTPUT) ;// define LED as output interface pinMode (buttonpin, INPUT) ;// output interface defines the flame sensor pinMode (analoog, INPUT) ;// output interface defines the flame sensor Serial.begin(9600); } void loop () { sensor = analogRead(analoog); Serial.println(sensor); // display tempature val = digitalRead (buttonpin) ;// digital interface will be assigned a value of 3 to read val if (val == HIGH) // When the flame sensor detects a signal, LED flashes { digitalWrite (Led, HIGH); } else { digitalWrite (Led, LOW); } delay(1000); }
Arduino KY-026 Flame sensor module
- Product Code: Arduino
- Availability: 3
-
56 LE